Sun Fire V440
| 501-6344 |
501-6900 |
501-6910 |
501-7343 |
Motherboard
270-6344-05/06/07
June 2003 |
Motherboard
270-6344-06
May to July 2004 |
Motherboard
270-6344-07
September 2004 |
Motherboard
270-6344-07
January 2006
L |
| 540-5418 |
540-6276 |
540-6336 |
540-6682 |
501-6344 Assy/FRU
August 2003 |
501-6900 Assy/FRU
May to July 2004
Not Orderable |
501-6910 Assy/FRU
September 2004 |
501-7343 Assy/FRU
January 2006
L |
Jumper Settings
| LOCATION |
PINS |
SETTING |
DESCRIPTION |
| J4202 |
1-2
2-3 |
In
In |
Normal Real Time Clock (default)
Clear Real Time Clock CMOS |
| J4204 |
1-3 |
Out |
1-2=XIR 2-3=POR (default) |
| J4205 |
1-3
2-3 |
Out
In |
Flash Write Protected *
Flash Write Enabled (default) * |
| J4206 |
1-2
2-3 |
In
In |
Select ROMBO
Select Flash (default) |
| J4207 |
2-3
1-2 |
In
In |
Normal Flash (default)
Flash Recovery |
|
* Jumpering 1-2 has no effect because Pin-1 not connected. |
The Flash PROM is write protected when:
 J4205 Pins 2-3 are Not jumpered, or
the Keyswitch is in the Locked position
|
The Flash PROM is write enabled when:
J4205 Pins 2-3 are jumpered, and
the Keyswitch is in the Normal or Diagnostic position, and
the PROM_SB_WE_N signal is software-enabled
|
Device Paths
|
I/O
BRIDGE |
BUS |
MHz |
PATH |
| PCI Slot 0 |
1 |
A |
33 |
/pci@1e,600000/<device>@2,* |
| PCI Slot 1 |
1 |
A |
33 |
/pci@1e,600000/<device>@3,* |
| PCI Slot 2 |
0 |
B |
33/66 |
/pci@1d,700000/<device>@2,* |
| PCI Slot 3 |
1 |
A |
33 |
/pci@1e,600000/<device>@4,* |
| PCI Slot 4 |
0 |
B |
33/66 |
/pci@1d,700000/<device>@1,* |
| PCI Slot 5 |
0 |
A |
33/66 |
/pci@1c,600000/<device>@1,* |
| Net 0 (ce0) |
0 |
A |
33/66 |
/pci@1c,600000/network@2 |
| Net 1 (ce1) |
1 |
B |
66 |
/pci@1f,700000/network@1 |
| INT SCSI |
1 |
B |
66 |
/pci@1f,700000/scsi@2 |
| EXT SCSI |
1 |
B |
66 |
/pci@1f,700000/scsi@2,1 |
|
Sun Fire V440 Codename: Chalupa |
Notes
- The minimum operating system is Solaris 8 7/03.
- FAB 270-6344-06 replaced 270-6344-05 on 501-6344 in July 2004.
(WO_29511)
- 270-6344-07 was used to build 501-6344-09 in August 2004.
(Deviation WO_29629)
- 270-6344-07 was used to build 501-6344-09 in October 2004.
(Deviation WO_30188)
- 270-6344-07 replaced 270-6344-06 on 501-6344-10 in November 2004.
(Deviation WO_30189)
- The 501-6900/540-6276 was released in May 2004 and inactivated in
July 2004. It did not ship.
- Motherboard 501-6910 requires ALOM >=1.5.
Refer to FCO
A0245-1.
- Motherboard 501-7343 requires ALOM >=1.5.4.
(Refer to BugID 6335060)
- Refer to FAB article
1000080.1
for information on possible need for ALOM >=1.6.2.
- The 501-6344 includes OBP <4.15.1 with extended diagnostics disabled
by default.
The variable diag-level is set to min.
The variable verbosity is not available.
- The 501-6910 includes OBP >=4.15.1 with extended diagnostics enabled
by default.
The variable diag-level is set to max.
The variable verbosity is set to normal.
- The 501-7343 includes OBP >=4.16.4 with extended diagnostics enabled
by default.
The variable diag-level is set to max.
The variable verbosity is set to normal.
Memory Notes
- Bank, Rank, DIMM, and XOR Interleaving is supported.
- UltraSPARC IIIi supports single bank and dual bank DDR DIMMs.
- Two DIMMs of the same bank size (single or dual) and memory size form a
bank.
- The minimum requirement is two DIMMs in any Bank (B0/D0/D1 or B1/D0/D1).
- Memory error reporting identifies a failing Bank, not a single failing DIMM.
Motherboard Notes
- The Motherboard FRU includes Motherboard 501-6344, AC Wire Harness 530-3146,
Flex Circuit Cable 530-3147, and CPU/Memory Shroud 540-5285.
- Do NOT pull on AC Wire Harness connectors P9 or P10. The connectors attach
sideways to the Motherboard and are held in place by the CPU/Memory Shroud.
- The CPU/Memory Shroud holds Tomatillo heatsinks at U1501 and U2601 in place.
- Master Tomatillo interfaces include the ALOM/RSM Slot, Ethernet 1,
Flash PROM, I2C, ATA-100, PCI Slots 0, 1, and 3, SCSI, Serial B,
Serial PROM, Smart Card Reader, TOD, and USB 0-3.
- Slave Tomatillo interfaces include Ethernet 0, and PCI Slots 2, 4, and 5.
References
Sun Fire V440 Server Installation Guide, 816-7727.
-
Sun Fire V440 Server Administration Guide, 816-7728.
-
Sun Fire V440 Server Parts Installation and Removal Guide, 816-7729.
-
Sun Fire V440 Server Product Notes, 816-7733.
|
