Sun Fire X2200 M2 Server
 
Sun Fire X2100 M2 Server
 

GCS>Sun Microsystems>Servers>x64 Servers
 

When the platform OS is up and running, your console can be one of the following:

• a locally attached monitor
• a Java[TM] Remote Console on the ELOM GUI,
• a text based session on the serial console redirection in the ELOM Service Processor Command Line (CLI).

Please note BIOS menu or system boot message before platform OS up will appear on all these console.

When accessing a system console, please type any key and check if the console is responding to see if the console is working or not.

Please note that there might be a process blocking the console; press CTRL+C to break this process to see if there still response from the console.

If there is no console response to the key presses then the system may be hung. Refer to one of the following documents to troubleshoot further:

•  <Document: 1008401.1>  Troubleshooting Solaris[TM] x86 hangs
•  <Document: 1007053.1>  Troubleshooting Linux Hangs
•  <Document: 1017776.1>  Troubleshooting Windows Server hangs

1. Physically Console via locally attached Graphics Monitor

This is the easiest connection to check, assuming you have a monitor attached to the video connector on the back on the system and a USB keyboard.

2. Getting Console via ELOM GUI

If configured, you may use the ELOM GUI interface to control your server remotely using the built in Java KVM. You can use this even when the system is running in graphical mode, for example, X Windows.

• Open ELOM Service Processor GUI; to access enter https://<ELOM IP address> in a supported browser.
• Depending of the ELOM version installed on your system, there are different ways to get the Java Remote Console:
  • Select tab "Remote Control" and than "Redirection". To get the Remote Console for this system please click the button "Launch Redirection"
    - or -
  • Click the "Launch" button right next to the small thumbnail of the monitor screenshot.

Refer to Embedded Lights Out Manager (ELOM) Administration Guide For ELOM for you platform and ELOM version. Also see ELOM Administration Guide Supplement for Sun Fire[TM] if available for your platform at:

http://www.oracle.com/technetwork/documentation/oracle-x86-servers-190077.html

3. Getting console via ELOM Service Processor Command Line (CLI)

You can connect to a serial console redirection on ELOM. Please note that the serial console needs to be supported by your Operating System and needs to be Configured and enabled before.

• Log in to the Service Processor using the SSH command. NOTE: You will need the IP address of the Service Processor to do this:

        ssh -l <USERNAME> <IP_ADDRESS>
Passwd: changeme (default passwd)
-> start /SP/AgentInfo/console
console activate sucessfull
press ESC ( to terminate session...

Refer to Embedded Lights Out Manager (ELOM) Administration Guide For ELOM for you platform and ELOM version. Also see ELOM Administration Guide Supplement for Sun Fire if available for your platform at:

http://www.oracle.com/technetwork/documentation/oracle-x86-servers-190077.html

For information on how to set up on Red Hat Linux,
SuSE/Novell Linux, and Solaris OS please refer to Technical Instruction
<Document: 1019396.1> : "Sun Fire X2100 M2/X2200 M2 Server: Configuring OS console redirection".

This document contains normalized content and is managed by the the Domain Lead(s) of the respective domains. To notify content owners of a knowledge gap contained in this document, and/or prior to updating this document, please contact the domain engineers that are managing this document via the "Document Feedback" alias(es) listed below:

Normalization team alias: [email protected]

This solution has no attachment