| Processor |
| Number |
Two or Four Embedded Quad-Core CPUs |
| Architecture |
Type: Intel Xeon
- Quad-Core Intel Xeon E7338 (2x3MB L2, 2.4 GHz, 1066 MHz FSB, 80W)
|
| Cache memory |
6 MB Level 2 cache |
| Main Memory |
| Capacities |
DIMM slots per System: 32
DIMM type: DDR2 667MHz Registered DIMMs
DIMM size: 4-GB or 8-GB
Maximum capacity: 256GB (when configured with 8-GB DIMMs)
NOTE: For optimal performance,
install DIMMs in matched pairs.
|
| Standard
Integrated Interfaces |
| Network |
Four 10/100/1000 Base-T Ethernet Ports
|
| Network Management |
One dedicated 10/100Base-T Ethernet port |
| Serial Management |
One dedicated TIA/EIA-232-F asynchronous RJ45 port |
| SAS |
Eight channel SAS interface, SAS expansion board required for twelve disk drives |
| USB |
Front: Two USB 2.0 ports
Rear: Two USB 2.0 ports
Internal: One USB 2.0 port |
| Graphics |
One HD-15 VGA connector |
| PCI Expansion Slots |
Six PCI Express slots MD2 low profile (Note: One slot used for the SAS HBA)
(three x8 Mechanical/x8 Electrical, three x8 Mechanical/x4 Electrical)
Two PCI Express slots (Full Height, Full Length)
x16 Mechanical/x8 Electrical
Two PCI-X slots 64-bit/133MHz, 3.3V (Full Height, Full Legnth) |
| Alarms |
Four fail-safe, dry contact alarms (critical, major, minor and user) |
| Internal Mass Storage |
| Disks |
Up to twelve 2.5" SAS Disk Drives with add-on SAS Host Bus Adapter (HBA).
|
| Removable Media |
One Slimline slot-loaded DVD-R/W |
| Power Supplies |
Four redundant, 658W AC or 660W DC power supplies
Maximum AC input = 7.56A @ 100 VAC (Full output load 658W assuming min efficiency at full load 87%)
Maximum DC input = 18.75A @ -40VDC (Full output load 660W assuming min efficiency at full load 88%
|
| Environment |
| AC power |
100-240 V AC (50-60 Hz) |
DC Power
|
-48 V DC or -60 V DC (nominal)
-40 V DC or -75 V DC (range)
|
| Temperature |
Single, non-rack system:
Operating: 5° C to 40° C (41° F to 104° F)
Short Term: -5° C to 55° C (23° F to 131° F)
Nonoperating: -40° C to 70° C (-40° F to 158° F)
|
| Humidity |
Single, non-rack system:
Operating: 5% to 85% relative humidity non-condensing
Short Term: 5% to 90%, non-condensing, but not to exceed 0.024 kg water/kg dry air (0.053 lbs. water/2.205 lb. dry air)
Nonoperating: up to 93% relative humidity noncondensing,
40° C (104° F) max wet bulb |
| Altitude |
Single, non-rack system:
Operating: up to 3000 m (9,850 ft.), maximum ambient
temperature is derated by 1° C per 300 m above 900 m
Nonoperating: up to 12,000 m (40,000 ft.) |
| Acoustic noise |
Single, non-rack system:
LwAd (1B=10dB)
7.1 B (operating)
7.1 B (idle)
|
Regulations
Meets or exceeds the following
requirements: |
| RoHS Compliance Level |
RoHS:YL |
| Safety |
UL/CSA-60950-1, EN60950-1, IEC60950-1 CB Scheme with all national differences, IEC825-1,2, and
CFR21 part 1040 |
| RFI/EMI |
FCC CFR 47 Part 15 Class A, EN55022/CISPR22 Class A |
| Immunity |
EN55024/CISPR24, EN61000-3-2, EN61000-3-3 |
| Telecommunications |
EN300-386 |
| NEBS |
NEBS Level 3 Certified by Telcordia |
| Seismic |
GR-63-CORE requirements for earthquake zone 4 |
| Certifications |
Safety: UL/cUL, UL DEMKO, CE, BSMI, CCC, GOST-R, S-Mark
EMC: CE, FCC, VCCI, ICES, C-Tick, MIC, CCC, Gost-R, BSMI Class A
|
| Dimensions and Weight |
| Height |
174.2 mm (6.86 in.) |
| Width (including bezel) |
445 mm (17.5 in.) |
| Depth |
530 mm (20.87 in.) maximum to PSU handles
505 mm (19.88 in.) to the rear I/O |
| Weight |
33 kg (72.6 lb.) fully configured w/o PCI cards
|
| Rack Mounting |
| Netra X4450 server racks (using either the X4059A, X4061A or X4076A rackmount kits) |
Racks are as follows:
- Sun Rack 938
- Sun Rack 1038
- Sun Rack 1042
|
