Fujitsu (Allegro) drives in Sun StorEdge[TM] 3310 SCSI array connected with Ultra[TM] 320 SCSI HBA can cause scsi bus resets and transport errors.

Asset ID:	1-72-1006888.1
Update Date:	2011-01-18
Keywords:

Solution Type Problem Resolution Sure

Solution 1006888.1 : Fujitsu (Allegro) drives in Sun StorEdge[TM] 3310 SCSI array connected with Ultra[TM] 320 SCSI HBA can cause scsi bus resets and transport errors.

Related Items


Sun Storage 3310 Array

Related Categories


GCS>Sun Microsystems>Storage - Disk>Modular Disk - 3xxx Arrays

PreviouslyPublishedAs
209553

Symptoms
On systems connected to a Sun StorEdge[TM] 3310 SCSI array or JBOD with Fujitsu drives via an Ultra320 SCSI HBA, can experience the following problems.

got external SCSI bus reset
Target x reducing sync. transfer rate
Target x reverting to async. mode

These messages could further be followed by read/write errors such as:

Jan 16 04:04:21 larempdb scsi: [ID 107833 kern.warning] WARNING: /pci@1f,4000/scsi@4/sd@0,5 (sd76):
Jan 16 04:04:21 larempdb 	Error for Command: write                   Error Level: Retryable
Jan 16 04:04:21 larempdb scsi: [ID 107833 kern.notice] 	Requested Block: 153264                    Error Block: 153264

Jan 16 04:04:21 larempdb scsi: [ID 107833 kern.notice] 	Vendor: SUN                               Serial Number: 1ACACDB1-05
Jan 16 04:04:21 larempdb scsi: [ID 107833 kern.notice] 	Sense Key: Unit Attention
Jan 16 04:04:21 larempdb scsi: [ID 107833 kern.notice] 	ASC: 0x29 (power on, reset, or bus reset occurred), ASCQ: 0x0, FRU: 0x0

The above messages could be a result of:

Speed negotiation between the Ultra320 SCSI HBA and the Sun StorEdge 3310 SCSI array.
bug 6195171 - Jasper2 320MB/sec does not function properly with Allegro-9 and Allegro-8.

Allegro drives are Fujitsu drives and all qualified Fujitsu drives for the 3310 are either Allegro-8 or Allegro-9 type drives.

Bug 2124572 is the same as the above bug but is specifically for the LSI 1030 host bus adapter as noticed in the messages below:

May 10 13:55:10 hwhlr-ph2 scsi: [ID 365881 kern.info] /pci@1e,600000/scsi@2,1 (mpt1):
May 10 13:55:10 hwhlr-ph2 Rev. 8 '''LSI, Inc. 1030''' found.
May 10 13:55:10 hwhlr-ph2 scsi: [ID 365881 kern.info] /pci@1e,600000/scsi@2,1 (mpt1):
May 10 13:55:10 hwhlr-ph2 mpt1 supports power management.
May 10 13:55:11 hwhlr-ph2 scsi: [ID 365881 kern.info] /pci@1e,600000/scsi@2,1 (mpt1):
May 10 13:55:11 hwhlr-ph2 mpt1: IOC Operational.
May 10 14:03:45 hwhlr-ph2 scsi: [ID 107833 kern.notice] /pci@1e,600000/scsi@2,1 (mpt1):
May 10 14:03:45 hwhlr-ph2 got external SCSI bus reset.
May 10 14:03:45 hwhlr-ph2 scsi: [ID 107833 kern.warning] WARNING: /pci@1e,600000/scsi@2,1 (mpt1):
May 10 14:03:45 hwhlr-ph2 mpt_check_task_mgt: Task 3 failed. ioc status = 4a target= 8
May 10 14:03:46 hwhlr-ph2 scsi: [ID 107833 kern.notice] /pci@1e,600000/scsi@2,1 (mpt1):
May 10 14:03:46 hwhlr-ph2 got external SCSI bus reset.
May 10 14:03:47 hwhlr-ph2 scsi: [ID 107833 kern.notice] /pci@1e,600000/scsi@2,1 (mpt1):
May 10 14:03:47 hwhlr-ph2 got external SCSI bus reset.

Resolution
Please review the following steps.

Refer to <Document: 1012309.1> SCSI bus reset & transport errors on Sun StorEdge[TM] 3310 SCSI array with Ultra320 SCSI HBA

The above document helps to resolve any issues with the speed negotiation.

If inspite of resolving any issues with the speed negotiation, the problem persists, then most probably you are hitting bug 6195171.

The following patches are available:
SunOS 5.8 (sparc) 115275-07
SunOS 5.9 (sparc) 118558-18
SunOS 5.9 (x86) 119431-02 or Later
SunOS 5.10 (sparc) 119850-09 ( obsolted by 118559-29)
SunOS 5.10 (x86) 119851-09

Currently there is no x86 patch for SunOS 5.8

If the above still doesn't help, the following could contribute to this problem:

a) Disk firmware.
b) Hardware issue ( Cables,HBA,Motherboard etc)

Product
Sun StorageTek 3310 SCSI Array
Sun StorageTek Ultra320 LVD PCI Host Bus Adapter
Sun StorageTek Ultra320 SCSI PCI Express HBA, Dual port

Internal Comments
Fujitsu (Allegro) drives in Sun StorEdge[TM] 3310 SCSI array connected with Ultra[TM] 320 SCSI HBA can cause scsi bus resets and transport errors.

The x86 T-patch can be obtained by contacting the bug responsible engineer for bug 2124572

mpt, scsi bus reset, 3310, ultra320, transport errors, SE3310, JBOD, mpt.conf, minnow, Jasper320
Previously Published As
89259

Change History
Date: 2007-06-28
User Name: 7058
Action: Approved
Comment: See previous comments.
Activated link to 80089
Version: 4
Date: 2007-06-28
User Name: 7058
Action: Update Started
Comment: Update to activate link to 800089
Notes for Normalizaton:
This document is referenced by: 80089 which is referenced by 89047
Subset Root path:
89259-->80089-->89047-->89034-->89031-->89050
Project: Minnow Normalization
Version: 0
Date: 2007-05-17
User Name: 31620
Action: Approved
Comment: Verified Metadata - ok
Verified Keywords - ok
Verified still correct for audience - currently set to contract
Audience left at contract as per FvF at
http://kmo.central/howto/content/voyager-contributor-standards.html
Checked review date - currently set to 2008-05-08

Attachments

This solution has no attachment