Netra[tm] T1 AC200 / DC200 Servers: Repair Procedures
This section provides the most common repair procedures for the
Netra T1 AC200/DC200, which are included in the following manual:
 Netra T1 AC200 and DC200 Server User's Guide (806-5978)
The following table provides the page numbers for
each procedure.
| Component |
Tips |
| CD-ROM Drive |
|
|
Disk Drive
|
-
Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected outages due to a spindle motor issue (FIN I1136-1).
- When inserting a hard disk drive into its enclosure, make sure the
top of the disk drive is touching the top of the enclosure. If you try
to install it with the bottom of the disk drive touching the bottom
of the enclosure, the drive will not align with the slide rails inside
the encloser, and you will not be able to insert the drive. (Product
Notes, 806-6134)
- 18.2GB and 36GB IBM disk drives may be susceptible to early life failures
problem (FIN I0724-2).
- Systems with 18.2GB and 36GB IBM disk drives may experience higher than expected failure rate.
(FCO A0182-2).
|
| Netra T1 AC200 (entire system) |
- This procedure provides instructions to replace an entire system,
because you can re-use an old server's MAC address, serial number, and
NVRAM settings into the new system.
|
| NVRAM |
|
|
