Sun Microsystems, Inc.   Sun System Handbook - ISO 3.4 June 2011 Internal/Partner Edition
   Home | Current Systems | Former STK Products | EOL Systems | Components | General Info | Search | Feedback

Sun StorEdge[tm] L1000 Tape Library - Repair Procedures

Technical support is supplied by ATL/Quantum in EMEA and the Americas; Sun provides support in all other locations.

This section provides the most common repair procedures for the L1000. The repair procedures are provided in the following manual:

Sun StorEdge L1000 Service Manual

The table below provides the page numbers that each procedure begins on.

Component
Page Numbers
Tips
Removing the Enclosure
6-3
 
Securing the X-Chassis in the Maintenance Position
6-4 - 6-5
When the x-chassis is in a raised position, and the left side y-axis belt is removed, (disengaging the y-axis motor) the x-chassis must be secured in its raised position or it will slam to the base of the cabinet.
Removing Y-Axis Stepper Motor
6-6 - 6-7
 
Removing X-Axis Stepper Motor
6-8 - 6-9
 
Removing Power Supply
6-10 - 6-11
 
Removing X-Axis Timing Belt
6-12 - 6-13
 
Removing Power Switch
6-14 - 6-15
 
Removing Single & Double Fan Bracket Assemblies
6-16 - 6-17
 
Removing 41 CFM Fan
6-18 - 6-19
 
Removing 90 CFM Fan
6-20 - 6-21
 
Removing Differential Wide SCSI PWA
6-22 - 6-23
 
Removing Y-Axis Timing Belt
6-24 - 6-27
 
Removing Right Door Assembly with Control Panel Display
6-28 - 6-29
 
Removing DLT7000 Differential Tape Drive
6-30 - 6-31
 
Removing Robotics Controller PWA
6-32 - 6-33
 
Removing Actuator PWA
6-34 - 6-35
 
Removing Passive Backplane PWA
6-36 - 6-37
 
Removing Y-Encoder Interconnect PWA
6-38 - 6-39
 
Removing X-Motor Interconnect PWA
6-40 - 6-41
 
Removing Extension / Rotary Assembly
6-42 - 6-43
 
Removing Load Pack Assembly
6-44 - 6-45
 
Removing Left Door
6-46 - 6-47
 
  Copyright © 2011 Sun Microsystems, Inc.  All rights reserved.
 Feedback